Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Terminal box GHG 791 01
Fig. 1
8 8 8 8 8
Cooper Crouse-Hinds GmbH
Explosion protected terminal boxes GHG 791 01 and
GHG 791 02
2
Safety instructions
The terminal boxes GHG 791 are
not suitable for Zone 0 and Zone
20 hazardous areas.
The operations must be carried out by
electrical suitably trained in hazardous
areea with knowledge of increased safety
explosion protection.
The temperature class and explosion
group marked on the terminal boxes shall
be observed.
The requirements of the EN 61241-0 and -1
regarding excessive dust deposits and
temperature to be considered from the
user.
Modifications to the terminal boxes or
changes of their design are not
permitted.
They shall be used for their intended
purpose and in perfect and clean
condition.
For replacement and repair only genuine
COOPER CROUSE-HINDS spare parts
shall be used. Repairs that affect the
explosion protection, may only be carried
out by COOPER CROUSE-HINDS or a
qualified electrician in compliance with
the respective national regulations.
Prior to taking the terminal boxes into
operation, they shall be checked in
accordance with the instruction as per
section 6.
Before the initial operation, any foreign
matter shall be removed from the
terminal boxes.
Observe the national safety rules and
regulations for prevention of accidents as
well as the safety instructions included in
these operating instructions and set in
italics the same as this text!
3
Conformity with standards
The apparat is conform to the standards
specified in the EC-Declaration of conformity.
It has been designed, manufactured and
tested according to the state of the art and to
DIN EN ISO 9001.
94/9 EC: Equipment and protective systems
intended for use in potentially explosive at-
mospheres.
The apparats fulfil further requirements, such
as the EC directive on electromagnetic
compatibility (2004/108/EEC).
4
Field of application
The terminal boxes GHG 791 01 and GHG
791 02 are suitable for use in Zone 1 and 2
as well as in Zones 21 and 22 hazardous
areas acc. to IEC 60 079-10 and
IEC 60 079-14!
The enclosure materials employed, including
the exterior metal parts, are made of high-
quality materials which ensure a corrosion
protection and resistance to chemical
substances corresponding to the
requirements in a "normal industrial
atmosphere":
- impact resistant polyamide
- special steel AISI 316 L
In case of use in an extremely aggresive
atmosphere, please refer to manufacturer.
5
Use/Properties
The terminal boxes are intended for the
distribution of electrical energy e.g. light
circuits, heater circuits, control circuits,
intrinsically safe circuits etc. in hazardous
areas (see technical data). The temperature
class, explosion group and permissible
ambient temperature, see technical data.
The electrical limiting values that are
decisive for the intrinsic safety shall be
observed.
The terminal boxes can also be used in a
„normal industrial area".
The data as per point 3 and 4 shall be
taken into account with the use.
Applications other than described are not
permitted without COOPER CROUSE-
HINDS's prior written consent.
For the operation, the instructions stated
in section 7 of the operating instructions
shall be observed.
The user alone is responsible for the
appropriate use of this terminal box in
consideration of the basic conditions
existing at the plant (see technical data).
6
Installation
For the mounting and operation, the
respective national regulations (e. g. Betr.Si.V,
equipment safety law for Germany) as well as
the general rules of engineering shall be
observed.
Publicité
Table des Matières
