Buchi Rotavapor R-250 Pro Manuel D'utilisation page 77

Büchi Labortechnik AG
Manuel d'utilisation Rotavapor® R-250 Pro
AutoDest sensor cpl.
For automatic distillation. Measures temperature of cooling
media.
Vacuum is adjusted according to cooling capacity of conden-
ser.
Vacuum valve, 4 mm, 24 V, connection piece
12.5 mm
Electrical valve for vacuum regulation when operated with a
non-BUCHI vacuum pump.
Vapor duct with integrated sinter plate
The integrated sinter plate P3 protects the condenser as-
sembly against powder and dust during the drying process.
Cooling water flow sensor
Checks the flow of coolant, stopping operation when flow of
coolant is insufficient or interrupted.
Cooling water temperature sensor
Needed to display the coolant temperature for optimal dis-
tillation settings.
Cooling water valve
Eliminates unnecessary water waste by stopping cooling
water flow when not in use.
Level sensor for receiving flask
For defined concentration of product or to prevent an over-
flow of the secondary condenser if combined with a Va-
cuum Pump V-600 with secondary condenser
Stopper, PE, 120 mm
To close the evaporating flask
Communication cable. BUCHI COM, 15 m, 6p
Enables connection between Rotavapor®, Interface, Va-
cuum Pump, Recirculating Chiller, VacuBox and LegacyBox.
IQ/OQ R-250 Pro
official BUCHI document
Repeating OQ R-250 Pro
Splash protection (cpl.)
Evaporating flask 50 L
Réf. article
11064486
11055928
041100
11055971
11055988
041191
11056192
11057349
11064090
11071749
11071750
041420
041339
Annexe | 12
Schéma
77/80