Lid Assembly - vitapur GWF8L Guide D'utilisation Et D'entretien

OPERATING INSTRUCTIONS
Lower Chamber Assembly
1. Attach the float into the threaded float base
at the bottom of the lower chamber.
2. Place the assembled lower chamber on the water
dispenser.

Lid Assembly

3. To install the top lid cover ring onto the upper
reservoir, you must first separate, (remove) the lid
cover from the ring. Open the lid cover until the
1.
hinge pivots start to separate from the ring and
twist off.
3. Caution: Do not push lid back forcefully.
4. To install the lid ring onto the upper reservoir, lay the
ring on a solid flat surface with the open channel of
the ring facing upward. Position the upper reservoir
on the top ring making sure both contours are
aligned, and press fit together.
4.
Upper Chamber Assembly
5. Align the two ports and locking tabs at the bottom of
the pre-filter with the holes in the upper chamber of
the filtration system and snap it into place.
6. Twist the soaked filter onto the base of the
upper chamber of the filtration system. Securely
tighten the filter to the housing to make a tight
seal for effective filtration.
7. Re-attach lid to ring on the upper chamber
8. You can now place your assembled upper chamber
on top of the lower chamber.
Manual Filter Change Reminder
9. To use the manual filter change reminder, turn the
dial on the lid until the number in the green circle
coincides with the month that the filter is being
5.
installed. The number that appears in the red circle
will be the month to replace your filter. Repeat above
step for every filter change.
6. 9.