Carmen NC2110 Mode D'emploi page 6

6 • ENGLISH
Note:
• Every touch of the touch buttons is accompanied by a
sound signal and blinking of the button (5)
• Two sound signals indicate that the minimal or maximal
rotation speed was set.
• We recommend to use the low rotation speed for nails
treatment and higher rotation speed for rough skin
treatment.
• Select attachment rotation direction by touching the
button (5) , if the button glows red, the attachment
rotates counter clock- wise and if the button glows
green, the attachment rotates clockwise.
• LED illumination (3) is switched on when the unit is
switched on by the button (7) «0/I». To switch the
illumination off draw your fi nger from the button (4) «+»
to the button (5) slowly, to switch it on draw your
fi nger backwards.
• After operation switch the unit off by pressing the button
(7) «0/I» and take the power adapter out of the socket.
> ATTACHMENTS
.
We suggest some options for usage of the manicure/
pedicure attachments.
Attention: Always switch the unit off and remove the
power adapter from the mains before installing and
changing the attachments.
Felt cone (8)
Smoothing and polishing the edge of the nail after fi ling as
well as for cleaning the nail surface. Always polish in circular
movements and do not allow the felt cone to rest in one
place, otherwise friction could cause heat to develop.
Sapphire cone (9)
This attachment is used for smoothing of the nail surface
and rough skin areas. Gently move the attachment along the
treated nail or skin surface.
Flame milling cutter (10)
For removing ingrowing nails. Carefully guide the fl ame