LENCO PDR-03 Manuel D'instruction page 9

Manual set Time
Press and hold the INFO/MENU button to find the <Main menu> and
press ENTER, press
Then press ENTER button to enter the selection interface.
Press / button to select the digits of the time and date.
1. Set clock> Press ENTER> 00:00(Hour:Minutes)> Press /
the Hour digits> Press ENTER> Press
Press ENTER to confirm.
2. Set date> Enter the date 01-01-2014 (Day-Month-Year)> Use the
above steps of SET CLOCK to select the digits, press ENTER to confirm.
3. Auto update> Select No update or From radio> Press ENTER.
*If selected NO UPDATE, the time and date will not update from the
system, and you should manually set the time and date.
*If selected FROM RADIO, the time and date will auto update from the
system if it detects the RDS signal. But if the RDS signal is not strong
enough, the time/date will not update.
4. After finish the steps above, the time is set up manually.
Set the Alarms
1. When the <Alarm 1: off> appears, press ENTER to set the alarm ON,
press / , it displays: Time: 00:00, then press ENTER. Use
select alarm digits, press ENTER to confirm.
2. Select the alarm days: Daily, Once, Weekdays, Weekends.
3. Set the alarm mode: DAB, FM, Buzzer.
*Choose the DAB or FM mode as the alarm mode, when the alarm goes
on, the unit will turn on to the corresponding radio.
*Choose the Buzzer mode, when the alarm goes on, there comes a
audible sound, press ENTER button, the alarm will goes on again 5
minutes later. Press and hold the SLEEP button can stop the alarm.
4. Set the presets, this option enables the unit to turn on from the
preset station or the last listened station if the alarm mode is FM or
DAB with preset stations.
5. Set the alarm volume level, press
the volume level, press ENTER to confirm.
6. After all the above steps, enter the SAVE interface, press ENTER to
save the alarm 1. To set alarm 2, follow the steps of alarm 1.
7. To cancel the alarms, enter the alarm setting interface, press ENTER to
select off, then enter the SAVE interface to save the alarm off setting.
/ and press ENTER to enter the <Time setup>.
6
/ to select the Minute digits>
/ buttons to increase/decrease
to select
/ to