Dab Operation - LENCO PDR-03 Manuel D'instruction

DAB menu settings
Press and hold the INFO/MENU button, then press the / to enter
the <Main menu> in DAB mode.
Prune the station
When the radio has performed a scan in several locations, you may find
there are some stored stations that no longer receive. This prune
function automatically can remove them from the stored station list.
Enter the menu, press / to find <Prune station>, then follow the
tips <Press "ENTER" to prune station> to press the ENTER button.
Station order
Enter the menu, find <Station order>, press ENTER, then press / to
select one of the station order: Multiplex, Alphanumeric, Active, press
ENTER to confirm selection.
DRC (Dynamic range control)
This function enables the radio to reduce the dynamic range of audio
signal and adapts to be listened to the audio in noisy environment.
Enter the menu and find the <DRC>, use / to select from: DRC off,
DRC low, or DRC high, press ENTER to confirm.

DAB Operation

Scan stations
When turning on to DAB mode, the unit will auto-scan the stations it
found in this area. Press / button to select the previous or next
stations, and press ENTER to activate to play the station.
Station tuning
Press and hold the INFO/MENU button, when the <Station scan>
appears, press ENTER, then use the / button to cycle through the
scanning options: <Full scan>, <Manual tune>.
* Select the Full scan, and press ENTER to enable a full scanning.
* Select the <Manual tune> and press ENTER, use / button to
select station from 5A:174.928MHz to 13F:239.200MHz.
Then press ENTER button to activate the selected station.
8