Using The Water Dispenser; Child Safeguard; Features And Parts List; Loading The Dispenser - GE SmartWater GXCF05D Manuel D'utilisation

Using the water dispenser.

GXCF05D
Floor model
Child
safeguard tab
4
GXCC01D
Countertop model

Loading the Dispenser

IMPORTANT: Make sure the dispenser is
unplugged with both the hot and cold power
switches (on the back of the dispenser) set to the
0 (off) position. Before placing the water bottle on
the dispenser, wash hands and wipe the top of
the bottle with a clean cloth. Avoid touching the
part of the bottle that will be in contact with the
water dispenser.
Make sure the water level in the top of the
dispenser is low enough to allow for proper
bottle installation. Failure to do so may cause
the dispenser to overflow.
Sanitize the dispenser water tanks prior to
installing a full bottle of water for the first time
(see "Cleaning and Sanitizing the Water Tanks").

Child Safeguard

The HOT dispenser button is equipped with
a child safeguard that reduces the risk of hot
water being dispensed accidentally or by small
children. To use the button, slide the tab up
and press the button in.

Features and Parts List

Bottle Support Collar (WS28X10012)
Separator (WS28X10013)
Cold Water Tank
Hot (Red) and Cold (Blue) Power Switches
(back of dispenser)
Indicator Lights
The green light will be lit when the dispenser is
plugged in. The red and blue lights will cycle on
and off while the dispenser heats and cools water.
Hot (Red) and Cold (Blue) Water Dispenser Buttons
Dispenser Drip Tray (WS28X10016) and
Grille (WS28X10015)
Storage Cabinet
Do not use to store foods requiring refrigeration.
The cabinet is not refrigerated.
Shelf (WS28X10014)
Drainage Cap (floor models) (WS01X10008)
Silicon Stopper (floor models) (WS01X10007)
Retaining Clip (countertop models) (WS01X10010)
Rubber Drain Cover (countertop models)
(WS01X10011)
1. If the water bottle has a cap, push the
center plug out of the cap and into the
bottle before placing on the dispenser.
2. Place the bottle on top of the dispenser as
shown and into the bottle support collar.
Install the bottle quickly to minimize spills.
3. IMPORTANT: Press the hot and cold dispenser
buttons until water runs from both taps.
4. Plug in the dispenser.
5. Set the HOT and COLD power switches
(located on the top left rear of the
dispenser) to the I (on) position.
6. Allow 30 minutes for water to reach hot and
cold temperatures.
Contact a local water bottle distributor to purchase
water bottles.
The dispenser heats water to a temperature
of approximately 190°F (88°C). Water temperatures
above 125°F (52°C) can cause severe burns or
death from scalding. Children, the disabled and
the elderly are at highest risk of being scalded.
CAUTION:
Children should be
supervised by a parent when using this product.