Configuring - wtw Oxi 330i Mode D'emploi

Configuring

Baud
4 0 8
p
9 4
O
n T 3
1
Time
d 1
A r n
Y E
9
0 0
Day.Month
10
Configuring
Note
You can leave the configuration menu at any time with <M>. The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
l Switch off the measuring instrument.
l While pressing the <M> key, press <
l Select the required Baud rate with < > < >.
0
Selection: 1200, 2400, 4800, 9600 Baud.
l Then press the <RUN/ENTER> key.
l The air pressure is only displayed if an oxygen sensor is connected. Oth-
erwise, "---" appears.
mbar
l Continue with the <RUN/ENTER> key.
9
l Select the required calibration interval for oxygen measurements with
< > < >.
Selection: 1... 14... 999 d.
l Then press the <RUN/ENTER> key.
4
l Switch the automatic measuring range selection AutoRange on/off with
< > < >.
Selection: YES (On), no (Off).
S
l Then press the <RUN/ENTER> key.
ARng
l Select the date and time step-by-step with < > < >. In between, press
4
the <RUN/ENTER> key each time.
l When the last <RUN/ENTER> key has been pressed, the instrument
changes to the last active measuring mode.
>.
Oxi 330i/340i