Atlantic SOLWSL2 Manuel D'utilisation page 3

Hardscape Wall Light Installation
Hardscape Wall Lights are designed to be installed into walls
and columns, just under the capstone. The LED light strip
and driver can be replaced without removing the capstone.
The cord between the driver connection and the light is
approximately 19', enabling the driver to be left outside of
the column or wall for future access (see Figure 3). When
laying the base course of stone, either notch the cord into the
wall or leave a notch slightly larger than ¾" to pass the cord
through. If multiple lights are going to be installed, the notch
will need to be slightly larger to accommodate multiple cords.
Removing the driver will allow the cord to be pulled through
the notch; reattach the driver before connecting the light to
a power source. Failure to reattach the driver will damage
the light and void warranty.
When installing the mounting bracket, make sure to notch the stone for the ¼"cord (see
Figure 4). Test fit the mounting bracket and cord, so that it does not rock or put too much
pressure on the cord. The holes in the bracket are for glue points to hold the capstone and
bracket in place. The LED light strip can be replaced without removing the mounting brack-
et or capstone.
Figure 3.
Driver
Maintenance
Spout Light Maintenance
Replacement LED Bulbs are available for SOL Spout Lights. To loosen and tighten the brass lens
ring on SOL Spout Lights, use the included key. Simply place the key in the slots on the brass
lens ring to loosen or tighten. Ensure that all components are installed correctly after servicing.
Inspect the silicone gaskets for defects and proper placement before re-assembling. Ensure that
the lens ring is tightly secured before submersing the fixture.
Figure 2.
Figure 4.
1" Female
threaded T
¾" KF tubing
3