Pt 45 Bodypack Transmitter; Ck 55 L Lavalier Microphone; C 544 L Headset Microphone; Putting On The Microphone - AKG Acoustics V3TPT45 Mode D'emploi

Les langues disponibles

Microphone technique

PT 45 bodypack transmitter

Fix the microphone to the supplied lavalier clip or to the optional H 41/1 tiepin.

Clip the microphone onto the speaker's clothing, as close as possible to his or her

mouth.

The closer the microphone is to the speaker's mouth, the less danger there is of feedback.

NOTE

Make sure to aim the microphone towards the user's mouth.

Put the microphone on.

Bend the gooseneck so that the microphone sits to one side in front of the corner of your

mouth.

• If you hear excessive pop noise ("p" and "t" sounds are overemphasised unnaturally),

move the microphone capsule further away from your mouth (back or down).

• If the microphone sounds "thin" or flat, move the microphone capsule closer to your

mouth.

NOTE

• Find the optimum position during the soundcheck.

If (for instance,on an open-air stage) excessive wind or pop noise becomes audible, attach the

supplied foam windshield to the microphone.

Slide the windshield onto the microphone capsule.

Pull the windshield over the outer end of the microphone capsule.

A special moisture shield on the microphone capsule makes it harder for moisture and

makeup to penetrate into the microphone.

This prevents the microphone apertures from being clogged by perspiration or makeup, which

would make the sound dull and reduce the sensitivity of the microphone. Therefore, you

should never remove the moisture shield from the microphone.

The C 544 L headset microphone includes a replacement moisture shield in case the first one

gets damaged or lost.

Perception wireless

Table des Matières