Beurer HA 80 Pair Mode D'emploi page 39

2. Hold the device in one hand and use the other hand to grip the adapter that connects the
sound tube and the device between your thumb and index finger.
3. Turn the adapter anticlockwise while also turning the device clockwise.
4. As soon as the adapter has turned through approximately 90°, pull the sound tube off in an
upward direction. Hold the device firmly while doing so.
5. Pick up the new sound tube. Put the sound tube in position and, applying gentle pressure,
rotate it fully onto the device in a clockwise direction until the arrow on the front is again in
alignment with the device buttons.
6. Check that the sound tube is in place before you reinsert the battery and switch on the de-
vice.
If you have any problems removing the sound tube, try using a pair of tweezers, for example, to
grip the adapter.
Inserting the drying capsule
A drying capsule is included in delivery. Wearing the hearing amplifiers
behind your ear means they come into contact with your skin, and there-
fore also with sweat, for example. As a result, you should dry the devices
after each application to care for them properly.
Remove the drying capsule from the packaging and place it with slight
pressure inside the storage slot intended for this purpose.
The capsule has a colour indicator. As the drying capacity decreases
over time, the colour changes from bright orange to white. If the capsu-
le is a whitish colour, it no longer has any drying capacity and has to be
exchanged.
39