Preparing Hot Water - Atag CaféMax CM4111 Notice D'utilisation

YOUR COFFEE MACHINE
• If the fi lling chute is blocked (due to damp in the appliance or
because more than 2 measuring spoons have been inserted), use a
knife or spoon handle to push the ground coff ee down (fi g. 14).
Next remove the brewing unit and clean it together with the
coff ee machine as described in 6.1.1 and 6.1.2 on page 21, 22
and 23.
• To return to the mode for coff ee beans after making the coff ee,
turn the "coff ee strength/preground coff ee" knob to any coff ee
strength setting (the coff ee grinding mill is re-enabled).
14

5.2.7 Preparing hot water

Hot water can be used to warm up cups and to make hot drinks, such
as tea or packet soups.
Warning! Risk of scalding when the hot water nozzle is activated!
Escaping hot water can lead to scalds. Only activate the hot water
nozzle when there is a receptacle under the hot water nozzle.
1. Put the hot water nozzle in place (fi g. 15).
2. Place a container underneath the hot water nozzle (fi g. 15).
3. Press the "hot water" button
display shows HOT WATER. Once the programmed amount of
hot water has been dispensed, dispensing stops automatically.
For a few seconds the display shows PLEASE WAIT.... After that
the appliance is ready to make coff ee again and the last selected
coff ee setting appears on the display.
15
5.2.8 Making cappuccino or hot milk (coff ee and milk froth)
You can use this function to either make hot, frothy milk or
cappucino. To do this, use the special milk container. Rinse the
container under the tap when you are about to use it for the fi rst time.
1. Unfasten the lid of the milk container with a slight clockwise turn
and remove it.
2. Fill the container with suffi cient milk (preferably skimmed or
semi-skimmed milk at fridge temperature (about 5 °C) should be
used). Do not go over the MAX line engraved on the container
handle (comes to about 1000 ml).
GB 16
5 Use
. Hot water is dispensed; the
YOUR COFFEE MACHINE
3. Make sure that the suction pipe is correctly inserted (fi g. 16); next
place the lid back on the milk container and fasten it with a slight
anti-clockwise turn.
16
4. Pull the hot water nozzle off (fi g. 17).
17
5. Bring the milk container up to the nozzle (fi g. 18).
18
6. You can set the amount of froth on the milk to any level using the
slider on the lid (fi g. 19): 'CAPPUCCINO' or 'CAFFELATTE'
- CAPPUCCINO: very frothy milk.
- CAFFELATTE: not so frothy milk.
7. Once the milk container is put in place, the appliance suggests the
CLEAN
next step on the display: PRESS KEY X1 FOR CAPPUCCINO,
X2 FOR MILK ONLY.
19
5 Use
GB 17