Atag CaféMax CM4111 Notice D'utilisation page 67

YOUR COFFEE MACHINE
5. Carefully clean the inside of the machine. Scrape off the encrusted
coff ee in the coff ee machine using a wooden or plastic fork or
something similar that will not scratch the fi nish (fi g. 26).
26
6. Remove all the remains with a vacuum cleaner (fi g. 27).
27
7. Replace the brewing unit (A) by pushing it into the holder (B)
A
and the pin (C). Th e pin must be introduced into the tube (D)
E
at the bottom of the brewing unit. Now push fi rmly where it says
B
PUSH (E) until the brewing unit is heard fastening into place
C
(fi g. 28).
D
28
8. Once you have heard the unit clicking into position, make sure
that the red buttons have snapped back out, otherwise the service
door cannot be closed.
º Th e two red buttons are
29
GB 22
6 Maintenance
correctly snapped out (fi g. 29).
YOUR COFFEE MACHINE
º Th e two red buttons are
Notes
• If the brewing unit is not put in place correctly, i.e. if it can be
heard clicking into position and the red buttons are not properly
snapped back out, the service door cannot be closed.
• If the brewing unit can only be put into place with diffi culty, it
30 must be made into the right height (before inserting) by pressing
the brewing unit fi rmly together from top and bottom (fi g. 31).
• If it is still diffi cult to insert the brewing unit:
º Leave it out of the appliance, place the drip tray, close the
service door, switch the the main switch on the back of the
appliance to 0 and then to l again.
31 º Wait for all the lights to go off , then open the door, remove
the drip tray and replace the brewing unit.
º Replace the drip tray, complete with the grounds container.
º Close the service door.
6.1.3 Cleaning the nozzles and the milk container
Every time after heating milk or making cappuccino, the nozzles on
the milk container have to be cleaned (see 5.2.11 on page 19). Also
the milk container has to be cleaned regularly.
1. Unfasten the lid of the milk container with a slight clockwise turn
and remove it.
2. Pull off the suction pipe (fi g. 32).
32
3. Pull off the milk dispenser pipe and the slider on the lid (fi g. 33).
4. Carefully clean all the parts with hot water and detergent.
Th e parts of the milk container must not be cleaned in the
dishwasher!
33
6 Maintenance
not snapped out (fi g. 30).
GB 23