Bestron DFS45SCO Mode D'emploi page 27

MONTAGE - Assembling the fan
3
1. Unscrew the 4 screws (see figure 3A) from the motor housing (3B).
2. Place the back of the fan basket (with handle) (3D) on the shaft of the motor housing (3B), with the
handle (3C) at the top.
3. Secure the back of the fan basket with 4 screws (3A).
4. Slide the fan blades (3E) onto the shaft and fasten the screw.
5. Hang the hook on the front half of the fan housing (3F) on the rear half of the fan housing.
6. Fit the attachment bolt through the hole at the bottom of the front half and rear half of the fan housing
(3H) and tighten the bolt.
7. Close the locking clamps (3I) over the rim of both halves of the fan housing.
4
A
B
C
E
D
8. Remove the attachment bolt and knob.
9. Loosen the knob for the tilt adjustment and
the tilt-adjustment locking screw sufficiently
to allow the bracket to fit onto the stand.
10. Fit the attachment bolt through the motor
support and the stand, and tighten the knob.
11. Fit the locking screw into the recess in the
stand.
12. Fit the tilt-adjustment knob. The knob will fit
into the deep recess in the stand.
27
G
I
F
H
EN