Operating Notes; Sr 450 Receiver; Selecting Modes; Selecting Screens - Harman AKG WMS450 Mode D'emploi

>RETRY<: start a new search.
SAVE: >Y< save your setting.
SAVE >N< reject your setting.
Diagram 10: Automatic search for
clean frequencies for a
multichannel system.

4.1 SR 450 Receiver

4.1.1 Selecting Modes

4.1.2 Selecting Screens

LOCK Mode:
LOCK
AUTO
SETUP Mode: LOCK
GROUP
3 sec.
Diagramm 11: Selecting screens.
28
3 Setting Up
AUTO
CHANNEL
>NAME<
">AT<"
>GROUP<
">3.0<"
>CHANNEL<
>SCAN<
">AT3.001<"
FREQ
SAVE >Y<
>FREQ<
>PRG IR<
>EXIT<
IR
3.9.1

4 Operating Notes

To toggle between LOCK and SETUP modes, press and hold the
When the receiver is in LOCK mode, the "LOCK" label is shown on the display. In SETUP mode, the
"LOCK" label is not shown.
Use and to select the desired status or setup screens. To call up the MHz screen, press and hold
and simultaneously for three seconds.
Frequency
"750.000 MHz"
AUTO
MHz (NAME)
CHANNEL
MHz
>NAME<
4. Use
the desired Preset.
5. Use
Frequency Group.
6. The receiver will automatically find
the next clean frequency.
As soon as the receiver has found a
clean frequency, the Subchannel
number assigned to this frequency
>RETRY< >EXIT<
will be displayed.
Clean frequencies are frequencies
where the receiver finds no RF signal
or an RF signal whose level is lower
than the current threshold setting.
SAVE >N<
>FREQ< 7. Refer to section 3.9.1: Program the
transmitter you assigned to channel 1
and leave power to the transmitter
ON.
AUTO CHANNEL
8. Repeat steps 1 through 7 above for
all other channels of your system. Be
sure to set each channel to the
same preset (country) as channel 1!
(Name)
Preset
"AT 3.0 02"
TX
Preset
Gain
>STATUS< >SQL<
and to select the name of
and to select the desired
key for about 1.5 seconds.
PRG
REHEAR EXTRA
IR
>INFO< >EXIT<
AKG WMS 450 V 1.10