Max Re-Bar-Tier RB398S Mode D'emploi Et Consignes De Sécurité page 17

No. Normal Operation
6. Wire twisting takes Wire gets entan-
place. gled.
Binding power is
weak.
Twisting-off
takes place.
Works properly
Warning
Problem
Sound
No sound
emitted.
A short beep
and a long
beep, repeat-
edly.
(Pipipipipipi...)
No sound
emitted.
No sound
emitted.
Two short
beeps.
(Pipi)
Cause
Wire, by hitting Rein- Check if wire hits Rein-
forcing bars, was re- forcing bars at binding.
pelted.
Binding wire has Turn off power and take
been entangled out battery to confirm if
around Twist sec- binding wire has been
tion. entangled inside curl
guide.
Reinforcing bars is Confirm size of Reinforc-
not of designated ing bars to be bound.
size. (SEE PAGE 12)
Erroneous handling Confirm how to apply Ma-
such as improper ap- chine to Reinforcing bars.
plication of Machine.
Function of curl Check if curl guide is left
guide switch open at binding.
Reinforcing bars is Confirm size of Reinforc-
not of designated ing bars at binding.
size. (SEE PAGE 12)
Erroneous handling Confirm how to apply Ma-
such as improper ap- chine to Reinforcing bars.
plication of Machine.
Low power remains Confirm the battery is ful-
in the Battery pack. ly charged.
The tool is used at Check the temperature at
low temperature. the job site.
17
What to Check
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
Turning off power, re-
move binding wire inside
curl guide.
Use appropriate diame-
ter scope.
Turning Torque dial
(Fig.1.5) in + and insert-
ing in vertical direction,
use as tilting at 45°.
(Fig.22)
Do not operate Machine
until binding is complet-
ed.
Use appropriate diame-
ter scope.
Turning Torque dial in –
(minus) and inserting in
vertical direction, use as
tilting at 45°. (Fig.22)
Perform normal charge
after the tying speed
slows down considera-
bly.
Leave the tool and the
Battery pack at normal
temperature in the room
for some time, and then
continue the operation.
Solution