User Tips; Exceptional Maintenance - RIHO IW00372.1 Manuel D'installation Et D'utilisation

Whirlpool 10 Button - User Manual
EN
6.2

User tips

In case of health problems: Consult your doctor before using the whirlpool system.
=
The maximum recommended duration for using the whirlpool is 10 minutes.
=
The whirlpool system should not be used immediately after a meal.
=
Bath foam (bubble bath), shampoos or soap should only be used after using the whirlpool system. If these media are
=
used prior to operation or when the Whirlpool bath is in operation, a great deal of foam will be generated.
7.0

Exceptional maintenance

WARNING:
Always switch off the power supply before carrying out any maintenance or other work.
ATTENTION:
The whirlpool service department cannot provide a service if there are no inspection hatches or the inspection
hatches are too small. In these cases, the customer has to make the whirlpool system available at his own
expense!
For extraordinary maintenance, please approach the authorised Service Centres. The guarantee will become void
if the product is used improperly by unauthorised personnel, and the manufacturer's liability for the safety of the
product will be cancelled immediately. If any parts fail, only use original and approved spares, otherwise the
guarantee will become void and the liability of the manufacturer for the safety of the product will be cancelled
immediately.
Detecting and resolving problems.
Problem 1.
The whirlpool does not work when the control panel is touched.
Cause 1:
The whirlpool is not connected to the mains.
Solution 1:
Connect the whirlpool properly.
Check the fuses.
Turn the power supply on.
Cause 2:
The water level is not high enough.
The electronically controlled whirlpools are fitted with a level sensor, and only allows the system to function when the
water level is high enough.
If there is sufficient water in the bath, check whether the water level sensor has come loose during transport or
installation.
Solution 2:
Add more water if the water level is too low.
If the level switch is loose, please contact a Riho service centre.
Problem 2.
The mini back jets do not work when the hydro motor is switched on.
Cause 1:
The valve stays shut.
Solution 1:
Switch off the mains supply using the main switch, wait 1 minute, then switch on again, thus resetting the electronics.
If the problem persists, please call your service centre.
Problem 3.
The cleanpool system does not work.
-13-