Troubleshooting Ice-Maker - AGA marvel ML24RFP0 Série Instructions D'installation, D'utilisation Et D'entretien

Problem
Unit operates but produces little or no
ice.
Small ice cubes
Ice cubes are sticking together.

TROUBLESHOOTING ICE-MAKER

Possible Cause
• The unit has just been started and
it has been less than 24 hours.
• Water supply is not turned on.
• Inadequate water pressure to unit.
• The ice-maker shut off arm is in
the uppermost / off position.
• Freezer section has not reached
temperature.
• Thermostat control set too warm.
• Condenser fan air flow is restrict-
ed.
• Room and/or water temperature is
too warm.
• The water pressure is to low.
• Water input may require adjust-
ment.
• Ice consumption is low.
• Hollow ice cubes with liquid cen-
ters that break when dispensed
into the bucket.
22
Remedy
• Typical ice production is 6 to 7
pounds per day. Allow for the
freezer section to reach tempera-
ture and the ice-maker to cycle
and accumulate ice.
• Turn on water supply to the unit.
• Water pressure to the unit must be
at a minimum of 20 psi.
• When the ice-maker shut off arm
is in the uppermost position, the
ice-maker is off. Flip the shut off
arm down to turn on the ice maker.
• Allow the freezer section to reach
temperature.
• Turn the temperature control to a
higher number to allow the unit to
run colder. Allow 24 hours be-
fore readjusting the temperature
control.
• Make certain the grille in front of
the unit is free and open for air cir-
culation. Clean grille as required.
• Move the unit to an area where
ambient temperature is below
90°F. The unit should not be
placed next to a heat source such
as an oven. Check for cold water
connection.
• The water supply line is kinked.
• Sediment build-up in supply line.
• Due to differing water pressures,
the ice-maker water input may
require adjustment. Contact a
qualified service technician.
• Ice will stick together if stored for
long periods of time.
• Ice-maker malfunction, call for
service.