Troubleshooting Your Beverage Center; Before You Call For Service - AGA marvel 6GARM Instructions D'installation, D'utilisation Et D'entretien

Before you call for service

If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshooting
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact your dealer or a
qualified service technician.
Electrocution Hazard
- Never attempt to repair or perform
maintenance on the unit until the main electrical power has
been disconnected. Turning the units control "off" does not
remove electrical power from the units wiring.
Problem
Unit not cold enough
Adjust temperatures (See "Set Tempera-
tures" on page 6)
Unit too cold
Adjust temperatures (See "Set Tempera-
tures" on page 6)
No interior light.
Light will not go out when door is closed
Noise or Vibration
Unit will not run.

TROUBLESHOOTING YOUR BEVERAGE CENTER

• Control set too warm
• Content temperature not stabilized.
• Excessive usage or prolonged door
openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Control set too cold
• Door gasket not sealing properly.
• Failed light bulb
• Door not activating light switch.
• Display light is turned on.
• Unit not level
• Unit turned off
• Power cord not plugged in.
• No power at outlet.
Possible Cause
17
Remedy
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at
least 24 hours.
• Airflow must not be obstructed to
front grille. See "clearances" on
page 4.
• Check door alignment and/or replace
door gasket.
• Adjust temperature warmer. (See
page 6, "set temperature"). Allow 24
hours for temperature to stabilize.
• Check door alignment and/or replace
door gasket.
• Replace light bulb, see page 16.
• Unit not level, level unit, (See page 4,
"leveling legs")
• Verify the door is aligned properly,
refer to page 10 for instructions.
• Turn off display light, shut door.
• Level unit, see "Leveling Legs" on
page 4.
• Turn unit on. See "Starting your appli-
ance" on page 6.
• Plug in power cord.
• Check house circuit.