AGA marvel ML24RFP0 Série Instructions D'installation, D'utilisation Et D'entretien page 15

Press and hold down this
tab on the wire connector
and pull the connector apart.
Figure 14
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 15. Set the gasket
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack.
OVERLAY DOOR PANEL INSTALLATION
Holes in
gasket
retainer.
Figure 15a
Figure 15
CAUTION
!
Weight of overlay door panel must not exceed 15
pounds (6.8 kg).
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 16 to 19.
15
Overlay panel
flush with top
and side of
door.
Overlay panel to
be centered on
width of door.
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.