Mosscade CAISSONS TITAN 05 Notice D'utilisation page 6

NEVER REMOVE DRIVERS OR AMPLIFIER FROM THE SUBWOOFER
To avoid any electric shock, never open the subwoofer. Mosscade's warranty does not cover
products that have been modified or exposed to rain, moisture or extreme heat.
Moving the subwoofer
Before changing the position of the subwoofer, unplug from AC outlet. Be careful when the
spikes are in place. Because of its weight, the subwoofer can damage the floor or the spikes.
The following solutions are available on the active Titans subwoofers :
•
For AV amplifier
Use the Cinch (RCA) "subwoofer" output connector of the
amplifier. Connect it to the red Cinch input connector (« low level
in » and "R/ mono) of the subwoofer at the bottom left..
•
For a triphonic system
Connect each output (left and right) of the amplifier to your
main speakers and to the subwoofer. To do so, use the "speaker
level in" input (B) on the subwoofer.
•
To use in a Home Theatre system (Dolby ProLogic, AC3, DTS, etc...)
Put the frequency cut off level control of the subwoofer (E) on
150Hz. Set the level of amplification of the subwoofer to mid
level (F). All other settings (equalizing of the subwoofer with
the main speakers) will be done from your AV amplifier.
•
For use in a triphonic system
For this solution, adjust the level o
frequency to the level of the main speakers.
C
ONNECTING THE SUBWOOFER TO THE AMPLIFIER
S
ETTINGS
f the subwoofer and its cut off
SUBWOOFER
INPUT