HELPFUL HINTS
The hand blender can be used in hot liquids. Always keep carefully when using it in hot
liquids. To avoid splashing when using the hand blender in a saucepan, insert it into the pan
first, scroll the speed controller down to "MIN", and then press the ON/OFF switch for
operation, slowly raising the speed to your desired setting.
CAUTION: Do not tilt or lift the blender out of the pan while the motor is running, because a
serious burn or injury may be caused by splattered food.
For thorough blending, please move blade up and down in mixture. Tall container such as
measuring cup is recommended for its better mixing result.
To cleanse the blender, remove the attachment and rinse it under running water immediately
after use.
Before turning the appliance on, immerse the hand blender attachment into prepared
ingredients first to ensure that they won't spill over.
For better mixing result, move the appliance in small outward spiraling circles when it's in
use. But don't touch the bottom of the container.
The hand blender cannot blend hard or fibrous ingredients unless they are smaller than 0.5
inches.
CARE AND CLEANING
● Unplug the unit from the outlet. Remove the blending rod, wire whisk or chopper
attachment from the motor base by push down the two round buttons. Cleanse the
attachment blending rod, wire whisk or chopper blade in warm, soapy water. CAUTION:
Blades are sharp. Handle with care. Do not immerse the chopper bowl cover, motor base,
cord or plug in water. Wipe the motor base and bowl cover with a damp cloth ONLY.
● If food residues are difficult to rinse off the blending rod or wirewhisk, place a drop of
dish detergent in a mixing container with appropriate amount of warm water. Immerse the
hand blender, power on, and operate for about 10 sec to self-clean. Then unplug it, rinse
the attachment under hot water.
● To clean the chopper attachment, remove the bowl cover first, and then the chopping
blade. The chopper bowl cover can't be immersed into water, so wipe it with a damp cloth
using dishwashing liquid if necessary; while the chopper bowl and chopping blade can be
washed in warm, soapy water. Do not use abrasive or harsh cleansers.
CAUTION: Do not try to sharpen the cutting edges of any blades. The are precisely honed
and might be damaged by any attempted sharpening.
Do not wedge plastic parts in the dishwasher as they could be warped.
CARACTERISTIQUES TECHNIQUES
Voltage: 220-240V~
Frequency:
50 /60 Hz
Power:
600 W
GB-7