Pentair Water Pool and Spa IntelliBrite 5g Guide D'installation page 9

Replacing the IntelliBrite Color Pool or Spa
(after electrical requirements are met)
The following removal and installation instructions describe how to remove and
install the IntelliBrite Pool or Spa light assembly. Also use these instructions after
completing the following light replacement procedure:
Failure to bring the pool or spa's electrical system up to code requirements
before installing the underwater light will create an electrical hazard which
could result in death or serious injury to pool users, installers, or others due to
electrical shock, and may also cause damage to property.
1. WARNING! Switch off main electrical switch or circuit breaker, and the
switch which operates the IntelliBrite underwater light.
2. 7R UHPRYH OLJKW ¿[WXUH DVVHPEO\ IURP WKH SRRO Remove the special
bronze pilot screw at top of face ring. Remove the IntelliBrite light assembly
from the niche and place it on the deck.
3. Cut the cord about 30cm from the back of the light assembly.
 5HPRYH -XQFWLRQ %R[ FRYHU GLVFRQQHFW WKH OLJKW ¿[WXUH ZLUHV DQG
pull the cord through the conduit. Tip: Before pulling the cord, tape
the new cord to the existing cord, This might make it easier to
feed the new cord through the conduit (see following step).
 )HHG WKH QHZ OLJKW ¿[WXUH FRUG WKURXJK WKH FRQGXLW IURP WKH QLFKH
to the Junction Box. Note: Depending on the length of the conduit,
special tools may be required to pull the cord through the conduit.
 /HDYH DW OHDVW PHWHU RI FRUG WR FRLO DURXQG WKH OLJKW ¿[WXUH VHH
Figure 1. This 1 meter of cord coiled around the light allows the light
WR EH VHUYLFHG DIWHU WKH SRRO LV ¿OOHG ZLWK ZDWHU
7. Cut the cord at the Junction Box, leaving at least 15cm of cord to
make connections.
8. Strip 15cm of the outer cord jacket from the cord to expose the three
insulated wires – Be careful not to damage the insulation on the
three inner wires.
9. Connect the two wires to the corresponding circuit wires in the
Junction Box (brown wire to power, Blue wire to common) and
secure the Junction Box cover in place.
10. Install the IntelliBrite light assembly into the niche and tighten the special
bronze pilot screw.
LED Light Assembly
9