Pentair Water Pool and Spa IntelliBrite 5g Guide D'installation page 5

®
IntelliBrite 5g Color-changing Pool and Spa Lights Overview
®
The IntelliBrite 5g underwater pool LED (light-emitting diode) light system gives you brilliant vivid
PXOWLFRORUV ZLWK VSHFWDFXODU HIIHFWV IRU \RXU SRRO 7KH HQHUJ\ HI¿FLHQW FRORUHG /(' DUUD\ FDQ F\FOH
through colors at varying speeds and in different sequences of color. Choose one of the seven pre-
SURJUDPPHG FRORU OLJKW VKRZV RU VHOHFW RQH RI WKH ¿YH ¿[HG FRORUV WR FUHDWH YLUWXDOO\ HQGOHVV UDQJH RI
dramatic underwater lighting effects.
Operating IntelliBrite 5g Pool lights (12 VAC model)
IntelliBrite 5g pool LED lights can be manually controlled using a standard wall-mount light switch.
Multiple IntelliBrite lights can be connected via a junction box to a single switch so that all lights can
be switched on and off together. IntelliBrite® lights can also be automatically controlled via Pentair
IntelliPool automation system®.
Using an External Transformer for Multiple IntelliBrite 12 VAC Lights
When using multiple IntelliBrite 12 VAC LED lights on a 300 Watt transformer, it is recommended
that no more than three IntelliBrite pool lights and one (1) IntelliBrite Spa light be used. It is also
recommended not to exceed 30 meter of total cable run between the transformer and light. Note: For
long cable lengths, set transformer to 14 VAC (see diagram below).
300 Watt
Transformer
300 Watt
Transformer
Troubleshooting
The light will not illuminate or does not function properly:
Check the GFCI ground fault wiring and reset if necessary.
Check the light wiring connection to the junction box at the pool side and to the AC power
switch.
Be sure that there is proper AC power applied to the light.
12 Gauge
J Box
(minimum)
45 m. max. for spa light
12 Gauge
J Box
(minimum)
60 m. max. for pool light
30 m.
5 5