Pentair Water Pool and Spa IntelliBrite 5g Guide D'installation page 20

Replacing the IntelliBrite Color Spa Light Face ring and
Gasket (P/N 640045) or Gasket and Lens (640046)
Note: When replacing an IntelliBrite Color Spa light assembly, a new
spa light assembly includes a light engine, lens, gasket and face ring.
1. Turn off main electrical switch or circuit breaker, as well as the switch
which operates the IntelliBrite underwater light itself.
leak into the assembly which could cause: (a) an electrical hazard resulting in
death or serious injury to pool users, installers, or others due to electrical shock, or
(b) breakage of the lens, which likewise could result in serious injury to pool users,
installers, or bystanders, or in damage to property.
2. REMOVING THE INTELLIBRITE SPA LIGHT: Remove the pilot screw at top
of face ring, remove the light assembly from the niche. Place the assembly
on the deck. Note: It is not necessary to drain down the pool.
the housing securely to the mounting ring and wet niche. Failure to use the screw
provided could create an electrical hazard which could result in death or serious
injury to pool users, installers or others due to electrical shock.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Always disconnect power to the pool light at the circuit breaker
before servicing the light. Failure to do so could result in death
or serious injury to installer, pool professional, pool users, or
others due to electrical shock.
Always install a new lens gasket whenever disassembling the
IntelliBrite light assembly. Failure to do so may permit water to
Pilot screw (bronze)
IntelliBrite Spa Light
Be sure to keep the pilot screw from the IntelliBrite
underwater light. This screw mounts and electrically grounds
D A N G E R !
20