52
Caution! Never operate the dryer
without fluff filters or with damaged or
blocked fluff filters.
Cleaning heat exchanger filters
If the warning lamp Wärmetauscher (Heat
exchanger) lights, the heat exchanger fluff
filters in the base of the appliance must be
cleaned
• Never operate the dryer without the fluff
filters.
• Clogged filters cause higher energy con-
sumption (drying cycle elongation) and
dryer damage.
• A dirty heat pump can only be cleaned
up by means of a costly process.
• As necessary, approx. once every 6
months, remove the fluff from the heat
exchanger using the sponge supplied.
When doing this, please use rubber
gloves.
WHAT TO DO IF ...
Troubleshooting by yourself
1)
Problem
Dryer not connected to mains supply.
Dryer does
not work.
Loading door opened.
The Start/Pause button not pressed.
Possible cause
* if necessary (approx. once every 6
months) remove the fluff from the heat ex-
changer using the sponge supplied (put on
rubber gloves)
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents
may form a barely visible lining on the
inside of the drum. The degree to
which the laundry has been dried is
then no longer detected reliably. The
laundry is damper than expected when
removed from the appliance.
Use a standard domestic cleaner (e.g. vine-
gar-based cleaner) to wipe down the inside
of the drum and drum ribs.
Clean control panel and housing
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the control
panel and housing.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the Start/Pause button.
6 *
7
10
9
Remedy