Fust NOVAMATIC TW740E Notice D'utilisation page 46

46
Important!
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be in-
stalled on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the appli-
ance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed be-
hind the lockable door, a sliding door a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the dryer is restricted.
Removing transport safety packaging
Caution!
Before use all parts of the transport pack-
aging must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current
and the fuses required should be taken
from the type plate. The type plate is fitted
near the loading aperture (see "Product de-
scription" chapter).
Warning! The manufacturer declines
any responsibility for damage or injury
through failure to comply with the
above safety precautions.
Should the appliance power supply ca-
ble need to be replaced, this must be
carried out by our Service Center.
Warning! The power supply cable
must be accessible after installing the
machine.
Door reversal
To make it easier to load or unload the
laundry, the door can be reversed.
Warning! The door must only be
reversed by an authorised service
engineer.
Please contact your local Service Force
Centre. The engineer will carry out the door
reversal at your cost.
Special accessories
• stack kit
Available from your Service Force Cen-
tre or your specialist dealer
These intermediate installation kits can
be used to arrange the dryer and an
washing machine (60 cm wide, front loa-
ded) as a space-saving washer/dryer
stack. The washing machine is at the
bottom and the dryer is at the top.
Read carefully the instructions supplied
with the kit.
• drain kit
Available from your Service Force Cen-
tre or your specialist dealer
Installation kit for direct draining of con-
densate into a basin, siphon, gully, etc.
The condensate tank then no longer has
to be drained, it must however remain in
its intended position in the machine.
Read carefully the instructions supplied
with the kit.
• pedestal with the drawer
Available from your Service Force Cen-
tre or your specialist dealer
To situate the dryer in optimal high and
have some additional space to store (e.g.
laundry).
Read carefully the instructions supplied
with the kit.
1