Oscartielle IDRA Self 100 Mode D'emploi page 19

The cabinet is designed for the display of food products, which are stored at the temperature of the product. It should not
keep them hot or cook them. The products must be displayed after cooking and at at a storage temperature eual and not
lower than +65°C.
Warning: Do not touch the inside parts of the cabinet used for heating.
Warning: Unplug at the mains before cleaning and wait until the warm components are cold.
Any liquid coming from dislayed food sould be immediately cleaned with a wet cloth. Please pay special attention to
glasses.
Clean the unit on a regular basis with neutral soap and then dry with a soft cloth. Never use flammable or abrasive
products. Never clean the unit with direct jets of water. When cleaning the inside of the unit, always wear protective
gloves.
Avoid that top lightings, electrical wiring and all electrical equipment are wet during cleaning operations.
Warning: Only plug the unit back in after checking that all parts (extracted or otherwise) are dry. Reload the unit following
the instructions in point 8.
Warning: If the unit doesn't keep the products warm enough:
- Check that the unit has been loaded properly; otherwise, see point 8.
- Check that the unit is not close to strong air flows (see point 4).
- Check that the unit is levelled and that the environmental conditions meet those indicated in point 4.
If the problem persists despite the above checks, contact your nearest service centre.
Warning: Never approach the cabinet in the event fire. Unplug at the mains. Never use water to put out any flames, but
only CO2 extinguishers.
15 - Service
If you require the services of an expert, and whenever you have to replace mechanical, electrical or compressors, the
user can contact the distributor where the cabinet was purchased, to order original spare parts.
16 - Dismantling and elimination of cabinet
For environmental reasons and in compliance with the regulations in your country, separate the parts of the cabinet for
disposal and/or recycling.
All the parts that make up the cabinet are made of materials that are not classifiable as urban waste except for the
metallic parts that are not classified as special waste in most countries. As regards the parts of the refrigeration circuit,
that is the refrigerating gas and lubricating oil, these should not be disposed of carelessly and can be recycled by
specialized centers.
The gas contained in foam polystyrene for thermal insulation of the cabinet is (CO
This product contains HFC, namely fluoridated gasses, a refrigerating gas with a high Global Warming Potential
(GWP) regulated by the Kyoto protocol.
Oscartielle equips its plug-in cabinets with the following types of refrigerating gasses:
R 290; GWP = 3
(100)
R 134A; GWP = 1300
(100)
R 452A; GWP = 2140
(100)
R 404A; GWP = 3750
(100)
This unit is hermetically sealed and the refrigerating gas load is under 3 kg.
For this reason it is not subject to the requisite of an installation booklet and periodic inspections for leakage of
the refrigerating gas (presidential Decree no. 147 of February 15th 2006, Art. 3 and 4).
17 - Manufacturer's declaration (Prohibition to use)
The models described above are constructed for possible assembly with other machines to form a processing line,
considered by Directive 2006/42/CE. Therefore the manufacturer declares that the equipment may not be used until the
line in which it is incorporated and of which it will be considered a part has been identified and declared to comply with the
terms of Directive 2006/42/CE and the national legislation that applies it, that is, until the machinery that is the subject of
this declaration becomes a single unit with the final processing equipment.
18 - Wiring diagrams
The diagrams can be seen in FIG. 13-14.
Legend:
AP = Output 230V
CA = Main power supply cable
CE = Electronic control
CS = Connecting cable
D = Defrosting heating element (Optional)
IG = Main switch
IL = Light switch
K1, K2, K3 = Relay
L = Phase
LV = Display case lights
).
2
17