Settings; Factory Setting; Individual Setting; Test Mode - Trilux +HFS Série Mode D'emploi Et D'installation

Settings

The sensor features three potentiometers for individual
setting:
Sensitivity/range
Hold time
Light threshold

Factory setting:

Sensitivity/range
Hold time
Light threshold

Individual setting:

Specific function settings can be increased or reduced by rota-
ting the corresponding potentiometer to the left or right.
TRILUX recommends setting the hold time to greater than 3
mins. to prevent a reduction of lamp service life.
12
100%
2 sec.

(test mode)

‚daylight'
Sensitivity/range
ca. 20%
100%
ca. 60%
Hold time
5 min.
ca. 2 sec.
(Testmodus) (Testmodus) (Testmodus) (Testmodus) (Testmodus) (Testmodus) (Testmodus) (Testmodus)
10 sec. 10 sec. 10 sec. 10 sec. 10 sec. 10 sec. 10 sec.
1 min.
Light threshold
ca. 50 lux
Test mode:
Test mode enables the functionality of the HF sensor to be
tested after installation. Rotating the hold time potentiometer
to its left end stop sets hold time to approx. 2 secs.
ca. 5 lux
13