Description; Items Supplied; Technical Data; Safety Instructions - Hilti PPA 20 Mode D'emploi

2 Description

2.1 Use of the product as directed
The PPA 20 is used to switch the PP 10/11 pipe laser on
and off, to activate horizontal alignment and to select the
laser beam mode remotely.
en
Modification of the tool is not permissible.

3 Technical data

Right of technical changes reserved.
NOTE
Right of technical changes reserved.
Remote control operating range
Dimensions (L x W x H)
Weight (including batteries)
Power supply
Battery life (alkaline batteries)
Operating temperature range
Storage temperature range
Protection class
Working range of the remote control unit
Working range 1 (typical value)
Working range 2 (typical value)
Working range 3 (typical value)

4 Safety instructions

4.1 Basic information concerning safety

a) In addition to the information relevant to safety given
in each of the sections of these operating instruc-
tions, the following points must be strictly observed
at all times.
b) Take the influences of the surrounding area into
account. Do not use the tool where there is a risk of
fire or explosion.

4.2 Proper organization of the work area

a) Avoid unfavorable body positions. Make sure you
work from a safe stance and stay in balance at all
times.
b) Use the tool only within its specified limits.

4.2.1 Electromagnetic compatibility

Although the tool complies with the strict requirements
of the applicable directives, Hilti cannot entirely rule out
the possibility of the tool being subject to interference
2
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.

2.2 Items supplied

1 PPA 20 remote control unit
1 PPA 20 operating instructions
4 Batteries (size AAA cells)
In the pipe, from the front: 200 m (650 ft)
155 mm x 68 mm x 20 mm (6.1" x 2.7" x 0.8")
0.2 kg (7 oz)
4 size AAA cells
Temperature +20°C (68°F): approx. 8 months
-20...+50°C (-4 to 122°F)
-30...+60°C (-22 to 140°F)
As per IP 56 (in accordance with IEC 60529)
Operating from the front: 200 m (650 ft)
Operating from the control panel side: 45 m (150 ft)
Operating from above: 25 m (80 ft)
caused by powerful electromagnetic radiation, leading
to incorrect operation. Check the accuracy of the tool
by taking measurements by other means when working
under such conditions or if you are unsure. Likewise, Hilti
cannot rule out the possibility of interference with other
devices (e.g. aircraft navigation equipment).

4.3 General safety rules

a) Check the condition of the tool before use. If the tool
is found to be damaged, have it repaired at a Hilti
service center.
b) Although the tool is designed for the tough conditions
of jobsite use, as with other optical and electronic
instruments (e.g. binoculars, spectacles, cameras) it
should be treated with care.
c) Although the tool is protected to prevent entry of
dampness, it should be wiped dry each time before
being put away in its transport container.