Table Des Matières; General Information; Gerätebauteile; Componenti Dello Strumento - Hilti PPA 20 Mode D'emploi

ORIGINAL OPERATING INSTRUCTIONS
PPA 20 remote control unit
It is essential that the operating instructions
are read before the tool is operated for the
first time.
Always keep these operating instructions to-
gether with the tool.
Ensure that the operating instructions are
with the tool when it is given to other persons.
Contents
1 General information
2 Description
3 Technical data
4 Safety instructions
5 Before use
6 Operation
7 Care and maintenance
8 Disposal
9 Manufacturer's warranty - tools
10 EC declaration of conformity (original)

1 General information

1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
1.2 Explanation of the pictograms and other
information
Warning signs
General
warning
1 These numbers refer to the illustrations. You can
find the illustrations at the beginning of the operating
instructions.
In these operating instructions, the designation "the tool"
always refers to the PPA 20 remote control unit.
Component parts 1
PPA 20 remote control unit
Signal transmission aperture
@
Signal LED (blinks red when a signal is transmitted)
;
Target plate auto-centering button (possible only
Page
=
with the PP 11)
1
Self-centering buttons (press both simultaneously)
2
%
Button to move target axis to the left
2
&
Button to move target axis to the right
2
(
ON / OFF button
3
)
Laser beam mode button
3
+
3
4
4
5
Symbols
Read the Return waste
operating
instructions
before use.
Type identification plate
Hilti = registered trademark of
Hilti Corporation, Schaan, LI
PPA 20
Location of identification data on the tool
The type designation and serial number can be found on
the type plate on the tool. Make a note of this data in
your operating instructions and always refer to it when
making an enquiry to your Hilti representative or service
department.
Type:
Serial no.:
material for
recycling.
Type: PPA 20
Item No. 319796
Power: 6V=nominal / 80 mA
Made in Japan
en
1