Nicols C 2024 J Notice D'utilisation page 13

MANUAL: [??]
FFFFFFFF A
Or FFFFFFFF B
Or FFFFFFFF C
EDIT SCANNER CHASE :
1. Press [BLACK], to turn off correspondent LED indicate light.
2. Press [EDIT/RUN], to turn on relative LED indicate light, and enter the program state.
3. Press any one of the number keys(P1-P24) one time, to select edit chase number.
4. Then press numbers (P1-P20), to select controlled scanner and correspondent LED ON. If correspondent indicate LED not ON, it
means that scanner not be selected and Step 5 will no effect with it.
5. Move sliders of CH1-8 to change value or press [SB/SC] to change CH9-24 value, and slide (CH9-CH24) to call out the
corresponding scanner effect ( Control joystick to change value if X/Y channel be assigned to joystick).
6. Repeat steps 4 and 5 to program other scanners to get expect effect
7. Move sliders of [SPEED] and [ CROSS] set chase running speed and cross time
8. Press , to save current chase/step and enter next step editing. ( Press
steps to modify it and press
9. Repeat steps 4 to 8 to edit other chases/ chase steps
10. Press [EDIT/RUN] until relative indicate light off to quit program status and run program.
11. Repeat steps 2 to 10, to edit other chases.
RUNNING CHASES :
1. Press [EDIT/RUN] unit indicate LED OFF.
2. Press number keys (P1-P24) to select chase number and run it; if that chase number has not been edited, then the corresponding
LED will not ON.
3. Move sliders of [SPEED] and [CROSS] chase running speed and cross time. If [SPEED] or [CROSS] slivers is at bottom AUTO area,
then the chase will run as preset speed and cross time.
4. Press [ CORSS MODE] to change the running mode-- refer to 9. Duplex key instruction.
5. If you want to run program In manual and automatic at the same time, please set as following steps:
1) Press [MANUAL] and [RELEASE CHANNELS] and then LCD display (12345678; FFFFFFFFA).
2) Press [SA/SB/SC] to check channel status. If channel show O, move slider of that channel to release it and change status be F to
make sure it under program control. (O-- Channel under manual control; F--Channel run as program preset data)
3) Press [RELEASE CHANNELS] to save change and quit
4) Press P1-P20 to select scanner to run in both manual and automatic mode-- several scanners could be selected at the same time.
5) Press SA/SB/SC to select correspondent channel of selected scanner. Then this channel will under manual control only to active
manual and automatic modes at the same time (LED display O instead of F)
6. Press [BLACK] can make pause/play current chase-- correspondent LED light ON means pause and OFF means play as normal
SPECIAL SCENE PRESENTATION :
In the stage of chase running (i.e., the indicating light of [RUN/EDIT] is OFF), press [RUN SCENE], then press any key of P1-P24 to
select 20 steps of 1 chase and 1
st
* Press MANUAL during program running:
[??] -- Display current running Chase/Step
FFFFFFFF A-- Show 1-8 channel status
FFFFFFFF B-- Show 9-16 channel status
FFFFFFFF C-- Show 17-24 channel status
O-- current channel under manual mode
F--current channel under auto mode
* Select one scanner or several scanners via P1-P20
*Press SA/SB/SC to select relative channel and move sliders of it to change status
again to save it)
4 steps of 2 chase. Therefore, we suggest to set first 24 steps with special effects.
st nd
, can view last chase or repeat above 4,5,6 and 7
Page 12