Functions; Remote Control - Steba VT 360 Twist Mode D'emploi

Functions

∙ Press the ON/OFF
with wind speed 1. If the device is turned off for a short time, it restarts with the
last set wind speed.
∙ By pressing the button
from 1 to 4.
∙ By pressing the button
o for normal program with wind speed 1 to 4
o for natural wind with different speeds
o for sleep mode
∙ The wind speed can be set regardless of the choosen mode.
∙ The right-left oscillation is turned on by pressing the button
program continues. By pressing the button again, the oscillationis turned off.
∙ By pressing the button
continues.
∙ If a specific setting of the air outlet should be fixed, interrupt the
oscillation by pressing the button
obtained. Further program settings are possible.
∙ The 3D oscillation and the right-left oscillation can be used simutaneously.
∙ By pressing the button
the button the time is changed by one hour. The display alternately shows the sym-
bols for the chosen mode and the timer. Once the time run out, the device turns
off. If the timer "0" is chosen, the timer symbol disappears after same seconds.

Remote Control

∙ The remote control is placed sidewise on the base of the device.
∙ The remote control can be used with a battery of type CR2025 or CR2032. Batteries
are not included to the scope of delivery.
, a signal sounds and the display lights up. The device starts
(or +/- on remote control), the wind speed can be set
(or „M" on remote control), the mode can be set:
, the 3D ocsillation is turned on. Th choosen program
the timer can be set from 1 to 8 hours.by the push of
. The choosen
once the desired setting is
11