Utilisation Of The Ice Crusher - R.G.V. Mojito Junior Manuel D'utilisation

Ice Crusher Commands
4 -
ON/OFF switch
5 - Safety switch
Ice Crusher Preparation
a1 - Place the motor unit (1) on a level, stable and dry surface. Make sure that all of the
suction cup feet (1c) are correctly attached to the work surface.
a2 - Place the funnel (2) in its seat (1a) located in the upper part of the motor unit (fig. B).
a3 - Insert the crushed ice container (3) in its aperture (1b) and push it all the way in so that
is correctly positioned (fig. C)
The safety switch (5) verifies the correct position of the
crushed ice container in the motor unit(3); if it is not posi-
tioned correctly the ice crusher will not start (fig. C).

Utilisation of the Ice crusher

b1 - Pour the ice cubes into the funnel (2) (fig. D).
Do not use "Cylindrical" (Spanish) ice cubes.
b2 - Connect the power cord to the electrical power outlet.
b3 - Start the ice crusher by pushing the ON/OFF switch (4) to "I".
b4 - The ice cubes "will drop" down into the motor unit to "come out" finely crushed into the
crushed ice container.
Do not push down on the ice cubes with your fingers or any
other objects (fig. E).
Do not insert too many ice cubes in the funnel (4) to avoid
their jamming. If this happens, empty the funnel (4) and then
reinsert the cubes a little at a time.
b5 - After use, turn off the ice crusher pushing the ON/OFF switch (4) to "O" and disconnect
the power cord from the electrical power outlet.
(fig. A)
EN
23