The ice crusher must be inspected and verified or repaired
only by an authorised reseller.
Any repair procedure performed on the ice crusher by unau-
thorised persons automatically invalidates the guarantee.
This ice crusher must be put only to the use for which it was
expressly designed and manufactured, that is, crushing ice.
Any other use is considered improper and therefore haz-
ardous.
The manufacturer cannot be considered responsible for
any eventual damages derived from improper, faulty or
unreasonable use of the ice crusher.
Should there be problems with the appliance, contact
an authorised service centres.
Avoid repairing the appliance on your own.
Any repairs carried out on the device by unauthorised
personnel will automatically invalidate the warranty,
even if it has not reached the expiry date.
Supplementary Warnings
-
Before connecting the ice crusher make sure that the information
tag data corresponds to the electrical power distribution
network (Mains) specifications. The tag is found on the back
of the ice crusher.
-
In the event of incompatibility between the outlet and the plug
on the ice crusher power supply cord, have the plug substituted
with another type that is suitable by professionally qualified
personnel who will also have to verify that the wire gauge for the
new plug is suitable for the power absorbed by the ice crusher.
It is strongly recommended that adapters, multiple outlets and/
or extensions NOT BE USED.
If their use were to be unavoidable it is then necessary to use
only simple, multiple or extension adapters that conform to the
safety regulations in force, paying attention to not exceed load
limits.
EN
21