Technical Data Table; Instructions For Installation; Installation; Laws, Technical Rules And Norms - Lotus cooker BSD-64EM Instructions Pour L'installation Et Mode D'emploi

Bain marie électrique sans eau

Table des Matières

Les langues disponibles

The data plate is on the front of the side (see diagram in electric connection item) and has all the data necessary for the

connection.

When fitting, the appliance must be levelled using a spirit level; slight differences of level can be adjusted by screwing

or unscrewing the adjustable feet. The main switch or the socket must be near the appliance and easily accessible.

It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed

near walls, dividing panels, kitchen furniture, decorative finishing, etc. , these should be in flameproof material;

otherwise it is necessary to cover them with non-flammable material.

Above all, it is necessary to ensure that the fire prevention norms are observed.

The installation, starting up and maintenance of the appliance must be carried out by qualified personnel. All operations

done when installing must be carried out observing the norms in force.

The manufacturer declines all responsibility in the event of incorrect functioning due to wrong installation or

installation which does not comply with the norms.

Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the

disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at

least 3 mm.

Installation must be carried out observing the following norms:

- Safety prescription in force

- Installation prescription in force.

The appliance is supplied without the electric connection cable. To install the power supply cable, proceed as follows:

•

Disconnect the power supply.

•

Remove the front panel

•

Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in

the junction box and fix them into place.

•

Block the cable with the cable blocker, and reassemble the front panel. The earth wire must be longer than the

others so that if the cable blocker should break, it will disconnect after the tension wires.

The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the

appliance and is identified by the

Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee

period for any damage caused, and which is due to inadequate installations not compliant with the instructions.

Attention! Use the appliance only under surveillance.

Dry steam cookers are appliances for heating and keeping warm fried foods (potatoes, fish, etc).