Operating Elements And Connections - IMG STAGELINE LTR-100 Mode D'emploi

GB Please unfold page 3. Then you can always see the
operating elements and connections described.

1 Operating Elements and Connections

1 Input via
at the rear will be switched off.
2 RATIO switch for selecting the transformation ratio
Switch not depressed: 1:1, output impedance = 600 Ω
Switch depressed:
3 PHASE switch for reversing the phase at the output
Switch not depressed: phases at the input and output are
Switch depressed:
4 GND switch for separating the ground connection between
input and output
Switch not depressed: ground connection between input
Switch depressed:
5 Output via
(6) at the rear will be switched off.
6 Output via XLR jack. This jack will be switched off when
1
the /
4
7 Additional GND screw connection
8 Input via XLR jack. This jack will be switched off when the
1
/ " input jack (1) is connected.
4
8
1
/ " jack. If this jack is used, the XLR input jack (8)
4
1
/ " jack. If this jack is used, the XLR output jack
4
" output jack (5) is connected.
2:1, output impedance = 150 Ω
the same
phase at the output is changed by
180° compared to the input
and output
ground separation between input
and output