Operating Elements And Connections; Safety Notes - IMG STAGELINE LTR-106 Mode D'emploi

Please unfold page 3. Then you can always see the oper -
ating elements and connections described.

1 Operating Elements and Connections

1 Input via 6.3 mm jack at the front. If this jack is used, the input
jacks (8+9) at the rear will be switched off.
2 RATIO switch for selecting the ratio
Switch not pressed: 1 : 1, output impedance = 600 Ω
Switch pressed: 2 : 1, output impedance = 150 Ω
3 PHASE switch for reversing the phase at the output
Switch not pressed: phases at the input and output are the
same
Switch pressed: phase at the output is reversed by
180° compared to the input
4 GND switch for separating the ground connection between
input and output
Switch not pressed: ground connection between input and
output
Switch pressed: ground separation between input and
output
5 Output via 6.3 mm jack at the front. If this jack is used, the
output jacks (6 + 7) at the rear will be switched off.
6 Output via XLR jack. This jack will be switched off if one of the
6.3 mm output jacks (5 + 7) is connected.
7 Output via the 6.3 mm jack at the rear. The XLR output jack
(6) at the rear will be switched off if this jack is connected.
8 Input via 6.3 mm jack at the rear. The XLR input jack (9) will
be switched off if this jack is connected.
9 Input via the XLR jack. This jack will be switched off if one of
the 6.3 mm input jacks (1 + 8) is connected.
10 Additional GND screw connection

2 Safety Notes

The unit corresponds to all required directives of the EU and is
therefore marked with .
G
This unit is suitable for audio signals up to 5 V only.
G
The unit is suitable for indoor use only. Protect it against drip-
ping water and splash water, high air humidity, and heat
(admissible ambient temperature range 0 – 40 °C).
G
Only use a dry, soft cloth for cleaning. Do not use any chemi-
cals or water.
G
No guarantee claims for the unit and no liability for any re sult-
ing personal damage or material damage will be accepted if
the unit is used for other purposes than originally intended, if
it is not correctly connected, operated, or not repaired in an
expert way.
GB
7