Delta UNISAW 36-L336 Manuel D'utilisation page 11

SWITCH
Switch is mounted underneath the front edge of the left
extension wing. To mount:
1. Insert two 5/16-18 x 1" flat head hex socket screws (A)
Fig. 8 through holes in front of wing and then through
switch mounting holes.
2. Place two 5/16" external tooth washers (B) Fig. 8
on the screws and secure screws from under the
extension wing using two 5/16-18 flange nuts (C).
ANTI-KICKBACK, RIVING KNIFE AND
BLADE GUARD ASSEMBLIES
The riving knife (J) Fig. 9 comes installed in the low, non-
through cutting position.
To assemble the anti-kickback and blade guard
assemblies, the riving knife must be in the raised position
as shown in Fig. 10. (See Riving Knife Operation and
Adjustment section for how to raise and lower the riving
knife.)
ANTI-KICKBACK ASSEMBLY
To reduce the risk of serious personal
injury, the anti-kickback assembly must be in place for
all possible cuts.
1. Locate the anti-kickback mounting hole (K) Fig. 10 at
the top of the riving knife (J) Fig. 9.
2. Slide the anti-kickback assembly (L) along the top of
the riving knife until the stem (M) Fig. 11 locates the
slot above the mounting hole.
3. Depress the stem (M) on the anti-kickback assembly
to allow the assembly to drop into the hole (K). Push
down on the anti-kickback assembly until it snaps into
place and locks.
NOTE: Pull up on the anti-kickback assembly to ensure it
has locked into place.
4. To remove anti-kickback assembly: Depress the
stem (M) Fig. 11 on the anti-kickback assembly and
pull it up off the riving knife.
A
11
A
C
FIG. 8
J
FIG. 9
K
FIG. 10
M
FIG. 11
B
L