Maintenance And Storage - Imetec S0001 Mode D'emploi

WARNING! This appliance is not to be used if it has been
dropped or if there are visible signs of damage.
• For fan operation, move the power switch (5) to the cool air position and adjust the ambient
thermostat (1) to the maximum temperature.
• For gradual heating, move the power switch (5) to the Warm air position I or the Hot air
position II and adjust the ambient thermostat (1) to the required temperature.
• For quick heating, move the power switch (5) to the rapid heating position III and set the
ambient thermostat (1) on the required temperature.
• To switch the appliance off, turn the power switch (5) to off.
Minimum temperature/ Anti-freeze function
This function assures maintaining the room temperature at around +5°C. The fan heater turns
on automatically as soon as the temperature falls below this value.
• Adjust the room thermostat (1) to the minimum temperature.
• Turn the power switch (5) to the warm air I or hot air II position to gradually achieve a
temperature of +5°C.
• Turn the power switch (5) to the Rapid heat position III to quickly achieve a temperature of
+5°C.
WARNING! Always disconnect the appliance from the mains
supply before cleaning or performing maintenance.
The fan heater may be cleaned using a soft, slightly damp cloth. Dry well after cleaning.
WARNING! Once you have finished using this appliance, make
sure it has cooled down completely before putting it away.
Keep the fan heater in a cool, dry place, out of reach of children.
NOTE: When you put the fan heater away, make sure it is well-protected from
dust.
USE

MAINTENANCE AND STORAGE

EN
13