Warning: Always test gas line for leaks at connector with soap water finishing all connec-
tions.
How to disconnect a gas bottle
a) Except for twin-cylinder installations with a changeover valve, turn off the gas tap if fit
ted to the appliance. Wait until the burner and pilot light have gone out. For installati
ons with a changeover valve, it is only necessary to switch off the empty cylinder.
b) Replace the orange safety cap onto the empty cylinder.
4.
Lighting instructions
Caution: The lid must be open when lighting the burner!
Do not stand with your face directly over the gas grill when lighting it.
Your gas grill will have following method of ignition.
Pilot Gas Control Ignition (Main burner or main burner with side burner):
With all gas controls on the Gas grill in the "OFF" position" OFF", turn the gas cylin-
der valve to the on position at the regulator. To create a spark you must press the con-
trol knob (A) and hold in this position for 3-5 seconds to allow gas flow and then turn
anticlockwise to" HIGH" (B). It can spark to the burner lighting tube (C). You will hear
a "snap" from the igniter and you will also see a orange flame coming from the burner
lighting tube at the left side of the burner (D).
Continue to hold the burner control knob in for two seconds after the "snap", this will
allow gas to flow completely down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned
to "HIGH"
At "High" setting the burner flame should be approximately 12-20mm long with a mini-
mum of orange flame. Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your gas grill following the above steps, contact
your dealer for advice.
If the automatic ignition can't be used, please remove the cooking grill and heat
diffuser(hotplate ), and turn the valve anticlockwise to 90°, to light with BBQ lighter in the
distance of 5mm to the burner fire hole. Replace the cooking grill and heat diffuser (hot-
plate), please wear the fireproof and heat resisting gloves.
Warning: If the burner still does not light ,turn the burner control knob to" OFF" and wait
5 minutes to let the gas clear before lighting again.
4
33