Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
• (Drinking) water network. Always in com-
bination with a system separator. The
use of a regulator stop is recommended.
NOTE: Use a standard water hose with
suitable coupling (s) for this.
WARNING: Never use the machine without
a system separator on the drinking water
network. Ensure that the connection of your
water installation to which the device is
connected is equipped with a system sep-
arator according to EN 12729 type BA.
WARNING: Water that has flowed through a
system separator is considered
non-drinkable.
Switch on / off
8.2
To switch the pressure cleaner on, hold
down the safety switch (1) and press the
main on / off switch lever (2) (see Fig. B).
Pressure setting
8.3
The machine has two pressure settings.
The high pressure setting is suitable for
thorough cleaning removal and the low
pressure setting is suitable for light cleaning
and watering (See Fig. I). The machine is
standard in high pressure mode. Press pres-
sure setting switch (eco) (3) to activate the
low pressure mode.
NOTE: Before use, remove the air in the
hose, hold the machine at your waist (max.
1.5 m above water source) and switch on
the machine. It can take around 30 seconds
for the water to reach the machine.
Select a spray mode
8.4
Choose a spray mode depending on your
work. Spray settings 0°, 15°, 25°, 40° and Jet
are suitable for cleaning and the spray posi-
tion with the spray symbol is best suited for
watering (See Fig. G).
WARNING: Do not change the spray setting
when the appliance is switched on.
Use of the foam sprayer
8.5
Always use the foam sprayer (9) in combi-
nation with the extension lance (7).
NOTE: When using on a (drinking) water
network, it must be ensured that the water
supply is blocked (by means of a regulator
stop, for example) when the pressure
cleaner is not being used. This prevents the
reservoir from draining.
6
— Attach the extension lance (7) to the
machine (See Fig. E).
NOTE: To attach, align the two tabs on the
lance with the cutouts as shown (See Fig. E)
— Attach the foam sprayer (9) to the exten-
sion lance (7) (See Fig. K).
NOTE: For mounting, align the two tabs on
the foam nozzle with the recesses in the
extension lance as shown (See Fig. K).
— Remove the soap bottle(18) from the
foam sprayer. This is attached by means
of a bayonet fitting.
— Fill the soap bottle with the appropriate
cleaning agent.
— Reattach the soap bottle to the foam
sprayer
— After use, remove the remaining cleaning
agent from the soap bottle.
9. Cleaning and maintenance
Remove the battery pack from the tool
before carrying out any adjustment, servic-
ing or maintenance.
Inspect the product for damaged or worn
parts before each use. Do not operate it if
you find damaged or worn parts. Contact
your supplier or the manufacturer for
replacement parts.
NOTE: For proper maintenance after
9.1
using with sea water, the product
should be rinsed by fresh water.
Hose filter maintenance
9.2
Rinse the filter with clean water.(See Fig. J).
Clean the molded plastic housing of the
machine using a soft brush and clean cloth.
Do not use water, solvents or polishes. Store
in a secure and dry place out of the reach of
children. Do not place other objects on the
product.
10. Cleaning/storage
Before storage, completely drain all the
water from the machine and hose.
Store the machine and the accessories in a
frost free place.
Publicité
Table des Matières
