Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Input – Plug your Bass into this 1/4" unbalanced input using a TS cable.
2.
Program Up/Down Buttons – Change the program number with these
buttons. When pressed together, they put the unit into both Bypass and
Mute modes and access the tuner.
3.
Display – indicates bank and program, shows parameter values, and
displays the pitch in tuner mode.
4.
EFFECT Knob – puts the Bassfire in PLAY mode or EDIT mode. You are
in EDIT mode when this knob is set to anything other than PLAY.
5.
VALUE Knob – adjusts parameter values and program numbers; stores
changes.
6.
DRIVE Knob – raises or lowers the level of the distortion effect.
7.
BASS Knob – adjusts the bass frequencies (independent of the EQ in the
EFFECT section).
8.
TREBLE Knob – adjusts the treble frequencies (independent of the EQ in
the EFFECT section).
9.
MASTER VOLUME Knob – controls the volume of the signal sent to the
speaker, headphones, STEREO LINK OUTPUT and SPEAKER OUTPUT.
10. HEADPHONES Jack – Plug in your headphones using a 1/4" stereo
plug.
11. Power Switch – turns the Bassfire on and off.
1.
Fuse – Replaceable fuse. See the rear panel of the Bassfire for details.
2.
Power Cord – Plug this cord into a proper AC outlet. See the rear panel
for details.
3.
FOOTSWITCH UP/DOWN INPUT – Plug footswitches into these 1/4"
jacks. Footswitches serve the same functions as the Program Up and
Down buttons.
4.
EXPRESSION PEDAL INPUT – Plug an expression pedal into this 1/4"
jack for easy control over EFFECT parameters.
5.
AUX INPUT – Plug a CD player or other audio device into these RCA
jacks and play along!
6.
STEREO LINK OUTPUT – Use a 1/4" TS cable to connect this jack to the
input of another amplifier for true stereo. The Bassfire provides true
stereo output instead of the standard mono; many of the Bassfire's
excellent effects will sound even better when you listen to them in stereo.
If you don't have a second amplifier, you can enjoy the stereo effects by
listening with headphones.
7.
SPEAKER OUTPUT – Use a 1/4" TS cable to connect this jack to an
external 8-ohm speaker. Doing so disconnects the internal speaker.
2
Front panel operation
Rear panel operation
Publicité
Table des Matières
