Copyrights And Trademarks - JVC CU-VD20E Manuel D'utilisation

Troubleshooting
If you think there is a malfunction, first check the following items. If you are still unable to solve the problem, consult your local JVC dealer.
Trouble
Cannot turn the power on.
The camera/PC is not recognized.
The burner or AC adapter is hot.
Cannot open the disc tray.
Writing fails.
Reading fails.
Writing/reading at maximum speed
is not possible.
Commercial DVDs cannot be played
when the burner is connected to PC.
It is impossible to dub the DVD discs,
which were written with this burner,
with DVD recorder with HDD.
Force Eject Hole
If a disc cannot be ejected with the eject button because of a malfunction, use this hole to eject the disc.
Force eject hole

Copyrights and Trademarks

Copyrights
Duplicating copyright protected material, for other than personal use, without the permission of the copyright holder is prohibited by
copyright law.
Registered Trademarks and Trademarks
®
● Windows
is either registered trademark or trademark of Microsoft Corporation in the United States and/or other countries.
● Other company and product names mentioned herein are registered trademarks and/or trademarks of their respective holders.
● Make sure the AC adapter is connected properly.
● Make sure the USB cable is connected properly.
● This is not a malfunction. If the burner is abnormally hot, remove the AC adapter and consult the
dealer from which you purchased the burner.
● A disc cannot be ejected by pressing the eject button if data is being written to the disc. Wait until
writing finishes.
● If a disc cannot be ejected with the eject button because of a failure or a malfunction caused by,
for example, the burner being dropped, use the force eject hole to eject the disc. (See below.)
● Make sure an appropriate disc is being used. (A pg. 3, 8)
● Use discs recommended for the burner. (A pg. 8)
● Insert the disc with the label facing up.
● Make sure the writing surface of the disc is not damaged.
● Make sure the disc tray is not dirty.
● Writing to irregularly shaped discs such as heart-shaped discs or octagonal discs is not possible.
● Check the writing speed of the disc being used.
● Insert the disc with the label facing up.
● Make sure the writing surface of the disc is not damaged.
● Writing to irregularly shaped discs such as heart-shaped discs or octagonal discs is not possible.
● Any CD recorded using the packet-write method cannot be played.
● Any CD that does not comply with standards such as the CD-DA standard (copy-control CDs)
cannot be played.
● Reading at maximum speed may not be possible if a non-standard disc is used.
● Use discs recommended for the burner. (A pg. 8)
● Check the region code. (A pg. 3)
● Connect the burner to the camera, playback using [PLAY DVD] function of the camera, and dub
the DVD discs with the DVD recorder.
(Refer to "Connecting to a TV, VCR or DVD Recorder" or "Using a DVD Burner for Dubbing" in the
camera's manual.)
Procedure
A Turn off the burner and disconnect the USB cable and AC adapter.
B Insert a thin rod of about 10 cm long into the force eject hole
C Pull out the disc tray manually and take out the disc.
NOTE:
Be sure to place the burner horizontally.
Cause/Action
located on the left side of the burner. The disc tray will be ejected
for about 10 mm.
EN 7