Removing The Doors And Hinges; Replacing The Doors - Crosley CS26G7DQ Manuel Du Propriétaire

I ,
NSTALLATION
CONT
Removing the doors
and hinges
Some installations require door removal
to get refrigerator to final location.
WARNING
To avoid severe personal injury or
death, observe the following:
• Disconnect power to refrigerator
before removing doors. Connect
power only after replacing doors.
• Green ground wire must be
attached to top hinge while
performing door removal and
replacement.
• Tape decorative panels (select
models) securely into place before
removing door handles.
CAUTION
To avoid property damage, observe
the following:
➢ Protect soft vinyl or other flooring
with cardboard, rugs or other pro-
tective material, prior to moving
refrigerator.
➢ To avoid damage or breakage to
adjusting bolt, do not use power
tools to correct leveling.
➢ DO NOT adjust refrigerator to be
any shorter than 68
hinge and cap). Doing so may
damage underside components.
3
.
1. Remove toe grille and bottom hinge
covers.
➢ Open both doors 180 degrees, or
as wide as possible to remove.
2. While pinching white collar (A) to the
blue connector (B), pull water line from
connector.
IMPORTANT: When reconnecting water
line, cut off tubing at first available scored
line before inserting into connector collar.
3. Remove top hinge cover by removing
Phillips screw.
" tall (minus
1
⁄
2
4. Close doors.
5. Unscrew
top hinges.
For dispensing models only:
• DO NOT remove either green
ground wire or wire connecting
center screw.
A
B
" hex head screws from
5 ⁄
16
6. For dispensing models
Detach main wire connector harness
and red wire harness.
➢ To detach main wire harness, use a
flat blade screwdriver or fingernail
to press junction point between two
connectors to release.
➢ To detach red wire harness, press
tab on underside of connector to
release.
7. Remove top hinges along with doors.
8. Remove bottom hinges with a
head driver.

Replacing the doors

➢ To replace the doors, follow the steps
in Removing the Doors and Hinges
in reverse order.
IMPORTANT: When reconnecting water
line, cut off tubing at first available scored
line before inserting into connector collar.
only:
3 " hex
⁄
8