Cleaning After Each Use - EYENIMAL PROFESSIONAL PET CLIPPER Guide D'utilisation

5. Attach the new blade set onto the blade hinge (Diagram 4).
6. Switch the clipper on, then push the blade set towards the clipper to lock it into position until it
audibly clicks.
Diagram 1

Cleaning after each use

Remove any stray hairs or debris from the appliance after each use. Clean the blades and combs by
blowing on them or use the included cleaning brush.
Maintenance
Clean your Professional Pet Clipper regularly with a slightly damp, soft cloth.
After cleaning the blade set, dispense a small drop of lubricating oil of your choosing on the 5 most
important points (Diagram 5) and switch the device on for a few seconds (approx. 10 seconds) to
ensure the oil is evenly distributed.
How to groom your pet
Dirt and sand caught in your pet's coat can damage the blades. That is why we recommend bathing
and drying your pet carefully prior to grooming. Untangle your pet's coat if necessary.
Acclimate your pet to the clipper sound, by gradually bringing the clipper closer to them while speaking
in a soft, soothing voice, petting and comforting them.
Start by trimming the face and throat, then run the clipper on the neck and shoulder area. Move on to
the back, rump, sides and belly. Work your way to the chest, then end with the legs (it is easier to clip
the legs when held in straight position).
Hold the blade safely against your pet's body, and clip slowly in the direction of hair growth, making
sure to keep the blade parallel to the skin. Make successive lines, trying as much as possible to finish
each line so as to avoid clipping the same area several times.
Face and throat should be clipped opposite the hair growth pattern.
To clip paws, place the blade at the nail bed, and run the clipper slowly along each toe, opposite the
hair growth pattern. Beware of cutting your pet's skin between the toes.
Diagram 2
Diagram 5
Diagram 3 Diagram 4
8