Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - Crosley CUD4000T Guide D'utilisation Et D'entretien

RINSE ONLY
Use this cycle for rinsing dishes, glasses, and silverware that will
not be washed right away.
Do not use detergent with this cycle.
Wash Rinse Rinse Main
Wash

Canceling a Cycle

You can cancel a cycle at any time.
1. Turn the cycle control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the cycle control knob to Off.

Changing a Cycle or Setting

You can change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the cycle control knob clockwise.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE: Turning the cycle control knob can cause the covered
detergent dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
4. Close the door firmly until it latches. The dishwasher starts a
new cycle.

Adding Items During a Cycle

You can add an item anytime before the main wash starts, or the
cycle control knob reaches Normal Wash.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
Rinse Final Dry Time
Rinse (min)
20
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
anytime before drying begins.
No Heat Dry
Select this option to dry dishes without heat and save energy.
Water
The dishes take longer to dry, and some spotting can occur.
Usage
(gal/L)
2.9/10.9
For best drying, use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE: No Heat Dry is an option with all cycles except Rinse
Only.
Heated Dry
Select this option to dry dishes with heated air. For best drying
results, use a liquid rinse aid and heated drying.
NOTE: Heated Dry is an option with all cycles except Rinse Only.
Plate Warmer
Use the Plate Warmer cycle to warm serving dishes or dinner
plates.
NOTE: Use the Heated Dry option.
1. Close and latch the door.
2. Turn the cycle control knob to Plate Warmer.
3. Allow 8 minutes for the cycle to heat the dishware.
4. Turn the cycle control knob to Off.

Option Selections

11