Busch+Müller IQ-XSH Notice D'utilisation page 10

7. Operation
The headlight (dimmed beam) is switched on and off via the bicycle display or by pressing the handlebar
button for a defined period of time (approx. 2 sec.). The high beam function is switched on or off by
briefly pressing the button. The LED in the handlebar button lights up green when the dimmed beam
light is on, and blue when the high beam function is switched on. In case other road users are likely to be
dazzled, do not use the main beam function. Always watch out to dim the headlights in good time.
When pushing the handlebar button twice shortly and in quick procession, the headlight emits a warning
flash. Using this function is only permitted in situations where another traffic participants should be
warned that they are endangering others or themselves.
8. Miscellaneous
If the e-bike is cleaned with water, positioned upside down or transported on a car in rainy weather,
both the headlight and the handlebar button must be covered (e.g. using plastic bags) to prevent
moisture from entering.
Disposal: Electronic parts are no regular waste. They have to be disposed of as special waste!
Please note: The operation of sensitive, radio-controlled odometers may be impaired by LED
headlights.
18
9. Liability
In addition to the above-mentioned exclusions of warranty, we do not assume liability for any and
all other damage caused by improper handling (e.g. dropping the headlight, inadequate safety of
mounting and its consequences, submersion in water or other liquids etc.). Neither do we assume
any liability if the headlamp is opened or dismantled at any point other than the rear cover.
Have fun and enjoy safe cycling with your new headlight!
Technical modifications reserved.
Busch + Müller KG
58540 Meinerzhagen, Germany • Tel. +49 2354 915-6000 • info@bumm.de • www.bumm.de
19