Installation; Notes On Safety For The Installation; Preliminary Checks; Working Position - Chappee TIGRA 2 CF 510 Manuel D'entretien

2

Installation

2.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner will be installed, and arranging the correct lighting of the environment,
proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
2.2

Preliminary checks

Checking the consignment
After removing all the packaging, check the inte-
grity of the contents. In the event of doubt, do not
use the burner; contact the supplier.
CAUTION
2.3

Working position

The burner must be installed in conformity with legislation and local standards.
The burner is designed to operate only in the positions 1, 2, 3 and 4 (Fig. 4).
Any other position could compromise the correct working of the appliance.
WARNING
Installation 5 is forbidden for safety reasons.
1
D4618
2.4

Burner assembly

The burner shall not operate without protection A)(Fig. 5) of the
suction inlet.
Installation
2 3
5
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and regula-
tions of the laws in force.
WARNING
The packaging elements (wooden cage or car-
dboard box, nails, clips, plastic bags, etc.) must
not be abandoned as they are potential sources of
danger and pollution; they should be collected and
disposed of in the appropriate places.
4
D5884
GB
5
Fig. 4
A
Fig. 5
20018247