Foundations 100SSE-SM Instructions D'installation page 3

For A. D. A. compliance, top of lower double stud should be
Recommended Blocking:
Wood double stud blocking is necessary. Contact an architect
complies with building codes (Fig b).
1. Slide changer into blocking area and mark mounting hole
location on blocking studs.
HINT: This may require 2 additional people to help hold
changer in position while you are marking the locations.
2.
3. Align holes in changer with marked holes and secure using
the appropriate fasteners (Fig. c).
NOTE: It is installers responsibility to provide correct
fastereners for other substrates.
4. Ensure all six (6) fasteners are tight.
Recommended Blocking:
If the walls do not have studs on center, then additional blocking
is necessary (Fig. d).
Contact an architect or building contractor to make sure the
blocking is adequate and complies with building codes.
For A. D. A. compliance, measure up 48 1/2" (122 cm) from the
left attachment hole.
NOTE:
- Changer MUST be mounted to studs (Fig. e).
-
unit is being tightened against the wall (Fig. f).
INSTALLATION - RECESSED
INSTALLATION - SURFACE-MOUNT
1"
(25.4 mm)
For A. D. A.
Compliance
28.25"
(72 cm)
A. F. F
Recess
Mounting
Holes
For A. D. A.
Compliance
48 1/2"
(122 cm)
A. F. F
Collar
Wall
Unit
Fig. f
2
34 1/2"
(876 mm)
(98.4 mm)
34 1/2" (876 mm)
Rough-in
Double Stud
19.4"
(492 mm)
Double Stud
Fig. b
Recess
Mounting
Holes
Fig. c
Top
32"
(813 mm)
on center
Fig. d
Surface-Mount
Holes
Fig. e
TOP
3 7/8"
VIEW
FRONT
21 3/4"
VIEW
(552 mm)
Rough-in
Recess
Mounting
Holes